What is the Discrete Wire Termination spec in IPC of Subminiature D-Connector? For Discrete wire termination of D-sub connector, the IPC spec as below.
Target - Class 1,2,3
• Wire ends flush with termination cover plates or extend less
than 0.5 mm [0.02 in].
Acceptable - Class 1,2,3
• Wire may extend to the end of free space.
Defect - Class 1,2,3
• Wire recessed (Figure 6-44).
• Wire is bent upwards in the free space over the top of the
connector body (Figure 6-45).
• Termination cover plate is broken or deformed (Figure 6-46,
47).
• Contact base metal is exposed (not shown).
• Contact is bent after termination and does not fit within the
termination cover slots (not shown).
• Covers are not fully seated against connector housing at
cover ends or cover is clearly convex at the center (not shown)
